| Step 1: Initially unplug your music system. | | | | purchased wire. Then make a Y junction by |
| Step2: Now disconnect your speaker wire from | | | | splitting the ends of the wire. Remove the |
| the music/home theater system. As you go | | | | insulation over the metal wire up to half - inch. |
| through the cable you can observe that the wire | | | | Step 5: The only thing you have to do is to |
| originating from each speaker consists of two | | | | connect the old set and the new set of wires. It |
| metal wires covered by flexible latex which works | | | | can be done in many ways. Among all soldering |
| as insulator. | | | | these two wires is the best option but a bit |
| One wire is the ground, while the other is the | | | | unsafe if you are soldering it for the first time. |
| positive. The tips of the wire towards the Y | | | | Using wire nuts is the best option in such cases. |
| junction must be peeled up to half inch. | | | | Step 6: You can follow the same steps for |
| Step 3: Buy some roll of wire the matches the | | | | multiple speakers. |
| one which is same as your speaker cable. This | | | | Step 7: Finally you have to connect the extended |
| information is given in the literature of your | | | | wires to the amplifier. Generally the positive goes |
| system or some times written on the cable itself. | | | | into the red one and the ground wire goes into |
| Along with these buy some wire connectors or | | | | the black one |
| nuts and electricians vinyl tape. | | | | Reconnect your system and enjoy music or |
| Step 4: According to the distance you want the | | | | movie of your choice. |
| speakers to be from them system, cut the | | | | |