Dell PA-9 adapter normally refers to the open circuit output voltage

First, the nominal voltage of power adapter Delltime connected chain, after going through the
inspiron 1300 Adapter Dell PA-6 adapter Dell PA-9filter capacitor will become flat after some, but
adapter normally refers to the open circuitthe ripple coefficient remains high (ripple
output voltage, that is, do not take any load,coefficient is the same magnitude of voltage
there is no current output voltage value.signal fluctuation the average voltage ratio, the
Therefore, that this is the power supply outputsmaller the closer description voltage direct
voltage limit. For the internal use of the initiativecurrent), the so-called nominal voltage refers to
power supply unit or voltage regulatorthe time integral of this voltage divided by the
components of the benchmark, in general the useintegration time, simple to understand is the right
of high resistance DC voltmeter can be directlytime, on average, if an ordinary DC Voltage Meter
measured nominal voltage (electromotive force, measured value is very close to the maximum
should be a more accurate method of bridgevalue of the voltage signal, so uncertainty. At the
belongs to the University of General Physicssame time, if the electricity fluctuate, the output
course experiment, not repeat them here), evenof such power will change as well.
if the mains voltage fluctuations in a certain place,In general, the real average no-load voltage of the
is secure in its output a constant value; but for apower adapter is not necessarily exactly the
small market, low-cost transformers, such as thesame nominal voltage, because the characteristics
Walkman and the like to the type used is basicallyof electronic components can not be exactly the
the traditional magnetic core transformer withsame, so it allowed a certain margin of error, civil
four rectifier diode bridge rectifier coupled with acases according to the need to control the use of
large filter capacitor on the bin, and so if you use0.1% to about 5%. The smaller errors, the
common dc voltage meter measured value will beconsistency of demand for electronic
greater than the nominal voltage, because thecomponents, the higher the cost of industrial
output of bridge rectifier pulsating DC, simply saidproduction, the higher the price of course, the
to be a sinusoidal voltage signal is a half weeks ofmore expensive.